Complete diagnostic cable for the diagnosis and reprogramming of SWM Euro 4 vehicles.

The cable consists of two connectors: one 6-pin connector (data communication) and one 2-pin connector (power supply).

To perform the diagnosis or reprogramming correctly, both connectors must be connected to the corresponding sockets on the vehicle. These sockets may not always be located close to each other. The power socket, fitted with a cap, is generally located near the battery or between the headlight and the dashboard.

NOTE 1: Some model series are not equipped with a 2-pin power supply socket. In this case, to power the diagnostic tool and ensure correct diagnosis or reprogramming, the 2-pin connector of cable 3151/AP51 must be connected to cable 3151/AP55, and the clamps of the latter must be connected to the vehicle battery.

We recommend always checking the connection instructions provided in the software.

NOTE 2: The cable does not support ABS system diagnosis. For this purpose, cable 3151/AP07 and end sleeve 7 must be used.